Terraforming Test

From Second Life Wiki
Revision as of 15:05, 26 April 2007 by Milo Linden (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

[TerraformingTest]

[VERSION] 0.1

[LENGTH] 00:30

[TESTERS] 1

[OVERVIEW] This script will test the land editing tools.

[SETUP] 1 normal user and at least 512m^2 of land

[*]

[NOTE] The 7 land tools to be tested are below, complete all stages for the test to be complete:

[*]

[SELECT]

[0010] User A, right-click the land -> Edit Land. Drag a square selection on the land.

[0020] Buy the land. Buy some nearby land in random chunks so that the footprint of your land is an irregular shape.

[0030] Join two parcels together into a L-shaped land parcel.

[*]

[FLATTEN]

[0040] While in land edit mode: double-click the L-shaped land parcel. Verify the selection outlines the parcel.

[0050] Select the "Flatten Land" radio button from the edit land floater.

[0060] Verify your cursor is a bulldozer when it is over the terrain.

[0070] Verify there is an indication of the area of effect for the tool (a grid of white dots).

[0080] While holding down the left mouse button: Drag your cursor around on your land parcel and verify it is being flattened.

[0090] Click the "Apply to Selection" button in the edit land floater. Verify that only the land parcel within the selection outline flattens.

[0100] Select the "Select Land" radio button in the edit land floater and drag-select a large rectangle that contains all of your land parcels.

[0110]Select "Flatten Land" from the edit land floater. Click the "Apply to Selection" button. Verify that the height of all of your parcels move toward an average height.

[*]

[RAISE]

[0120] While in land edit mode and the "Select Land" radio button is checked: Double-click the L-shaped parcel -> select "Raise Land" from the edit land tool -> click the "Apply to Selection" button.

[0130] Verify the L-shaped parcel raised a bit. Click the "Apply to Selection" button a few more times to raise your land to its maximum height.

[*]

[LOWER]

[0140] Select the "Select Land" radio button. Select the corner piece of the L-shaped land parcel (where the 2 lines connect).

[0150] Select the "Lower Land" radio button and click the "Apply to Selection" button.

[0160] Verify your land lowers the center of the L-shaped land parcel but leaves the ends at their former height.

[0170] Click the "Apply to Selection" button a few more lower the land to it's minimum height.

[*]

[SMOOTH]

[0180] Select the "Select Land" radio button. Select a square of land around all of your parcels.

[0190] Select the "Smooth Land" radio button and click the "Apply to Selection" button. Verify your land parcel smooths out.

[0200] Click the "Apply to Selection" button a few more times until there are no steep hills.

[*]

[ROUGHEN]

[0210] Select the "Select Land" radio button. Select a square of land around all of your parcels.

[0220] Select the "Roughen Land" radio button and click the "Apply to Selection" button.

[0230] Verify some parts of your land parcel raise or lower in a non-uniform way.

[*]

[REVERT]

[0240] Select the "Select Land" radio button. Select a square of land around all of your parcels.

[0250] Select the "Revert Land" radio button and click the "Apply to Selection" button.

[0260] Verify your land reverts to its previous state. (This state may not revert to the state you started with.)