Difference between revisions of "Follower script"
Jump to navigation
Jump to search
m |
m |
||
| Line 1: | Line 1: | ||
This script was extracted from the Batman Follower v1.2, but the following distance was changed from . | This script was extracted from the Batman Follower v1.2, but the following distance was changed from .3 m to .1 m. | ||
To set the following distance (distance between follower and followee), change the value denoted by # in '''llMoveToTarget(pos,#)'''. This script has it set at | To set the following distance (distance between follower and followee), change the value denoted by # in '''llMoveToTarget(pos,#)'''. This script has it set at .1 m. | ||
<code> | <code> | ||
Revision as of 16:05, 20 May 2007
This script was extracted from the Batman Follower v1.2, but the following distance was changed from .3 m to .1 m.
To set the following distance (distance between follower and followee), change the value denoted by # in llMoveToTarget(pos,#). This script has it set at .1 m.
default
{
state_entry()
{
vector pos = llGetPos();
llSetStatus(STATUS_PHYSICS, TRUE);
llSleep(0.1);
llMoveToTarget(pos,0.1);
key id = llGetOwner();
llSensorRepeat("","",AGENT,200000,7000*PI,.4);
}
sensor(integer total_number)
{
vector pos = llDetectedPos(0);
vector offset =<-1,0,1>;
pos+=offset;
llMoveToTarget(pos,0.1);
}
}
Note: The wiki code on this wiki is not working properly. Include the default { and the last } when copying and pasting this script into SL.